DIY: Origami rose in a stalk

The origami rose is an all-time favourite and it’s creation is truly ingenious. But one thing I didn’t like about the origami rose is it’s hollowness. So I tried modifying it and added a stalk to it.
Make a single stalk or an entire bouquet!

Supplies:

Origami paper
Blue Tack
Green wire (or a wire wrapped with green floral tape)
Pliers
Craft Glue


1. Create the origami rose from the instructions available here:

It can be quite difficult to follow initially, but with more practise it will turn out better.

2. Get a short length of green wire or any wire wrapped with green floral tape.

Make a loop at one end using a pair of pliers.

3.Wrap some Blue Tack around the loop. The amount of Blue Tack should be just enough to fit into the rose to make a sturdy rose.

4.Cut a smaller square piece of origami paper (with the same colour as the rose) and poke through the centre with the wire.

Wrap the paper around the Blue Tack.

5.Then fit the top of the wire into the hollow rose. Adjust the amount of Blue Tack until desired result.

Apply some glue to secure the wire and Blue Tack with the hollow insides of the origami rose.

6.And a sturdy origami rose is done!

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s